Jeff
Thank you very much. I'm tempted to give you a second tip of the hat..... but the 2 main headlights aren't working. The switches on the dash are all 'on'. Everything else is working OK.
This is the same problem that I'm getting with the CIRP Stalwart which you are investigating.
I don't know if it's relevant, but my default LIGHTS entry content was different to yours:
"[LIGHTS] //by jdl
//Types: 1=beacon, 2=strobe, 3=navigation, 4=cockpit, 5=landing, 6=Taxi, 7=Recognition, 8=Wing, 9=Logo, 10=Cabin,
//First=Light Type
//Second=fore and aft position use from middle - = back, + = forward
//Third=- = left and + = right
//Forth=-=Down, +=Up
light.0 = 3, 12.20, -11.45, -0.45, fx_navredSM //port mid
light.1 = 3, 17.4, -1.6, 6.0, fx_navredSM // port high
light.2 = 3, 12.7, 11.35, -0.35, fx_navgreSM //starboard mid
light.3 = 3, 17.4, 1.6, 6.0, fx_navgreSM //starboard high
light.4 = 2, 3.00, -11.50, -0.45, fx_strobe // Left ... 2, -2.45, -18.10, -0.49, fx_strobe
light.5 = 2, 3.00, 11.50, -0.45, fx_strobe // Right
light.6 = 1, -0.52, 0.00, 10.00, fx_shockwave_beacon_rotating_red //top center
light.7 = 1, -19.0, 4.55, 12.90, fx_navwhiSM //back top
light.8 = 5, 25.8, 1.3, -1.4, fx_landing
light.9 = 5, 25.8, -1.3, -1.4, fx_landing
light.10 = 5, 25.8, 1.3, -1.4, Fx_shockwave_landing_light_narrow // Shockwave light
light.11 = 5, 25.8, -1.3, -1.4, Fx_shockwave_landing_light_narrow // Shockwave light"
No biggie because I've replaced it.
I do have one observation for you:
In the 'Electrical' section of aircraft.cfg file there are these 6 lines that appear to refer to the lights:
light_nav=0, 5 , 17.0
light_beacon=0, 5 , 17.0
light_landing=0, 5 , 17.0
light_taxi=0, 5 , 17.0
light_strobe=0, 5 , 17.0
light_panel=0, 5 , 17.0
I was under the assumption that all lights were controlled in the LIGHTS section.
Do you know what they refer to?
Thanks again
Josh