FTX/ORBX/RTMM Scenery Library Placement

[jsapair]

I had everything working fine, had an insertion point set in FTX Cenral, etc., and never had a problem. Now it seems that the entire FTX block of entries has been moving itself upwards in priority...right to the top. I read over at FTX that by cycling from North America and back, FTX Central will insert their sceneries where they should be. Well, when Misty's place quit working I moved it above the FTX block of entries, as you'll see in the attachment, and it worked again. My guess is if that's what made Misty's Place work then all my other RTMM sceneries should be above the FTX block too. This is maddening.
   I guess my question is, do I have my insertion point set incorrectly? Should it be somewhere below the RTMM entries, and, if so, where exactly? Above Tongass? I'm sorry if I'm re-hashing old questions but I'm pulling my hair out here, and I don't have that much hair to begin with. I know this has been discussed before but I can't find the discussions. Any advice would be appreciated. BTW, I'm running FSX DX10 with FTX Global and Vector.
                                         JJ

[jeff3163]

Make your insertion point at the Orbx!OpenLC_Europe1.     All your RTMM stuff should be above FTX.

[Dieter]

I see, you'v got OZx installed:
There should be an insertion point for OZx, too.

http://www.orbxsystems.com/forum/topic/28291-adding-a-scenery-library-insertion-point-ftxcentral-step-by-step/?hl=+insertion%20+points&fromsearch=1

Dieter

[jsapair]

Thanks guys. That's just what I needed. Good tip on the OzX insert point too, Dieter. Never noticed that before.
                                               JJ