Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Bradallen43

Pages: [1] 2 3 ... 122
1
Hi Doc!!

Make sure you've disabled 5CD using the ORBX Vector Airport Elevation Correction utility found with Vector. Once you disable that airport, go back and check your pipes alignment. That should no longer be separated.

Here's a pic I just took at that same spot your picture was taken at. Using P3D and as you can see, no break with 5CD disabled using the Vector AEC utility.



Brad

2
Help and Troubleshooting / Re: PAVD - BWEP Pipeline Broken
« on: December 10, 2019, 07:52:17 PM »
No worries. We did just update some of the BWEP scenery for SAK Default and the Payware PAVD edition too. Two separate editions should give you a new and improved pipeline experience in and around Valdez.

FYI, I'm almost done with the entire pipeline and I'm approaching the final segments going into Deadhorse!!

Some final touches are needed and then, will issue BWEP: The North Slope soon.

Brad

3
NOTAMs and NEWs / Re: my confusion once again
« on: December 08, 2019, 09:33:22 PM »
?

4
Addon Scenery and Enhancements / BWEP: Gates of the Arctic RELEASED!!
« on: December 04, 2019, 10:46:09 PM »
On the BWEP Page now, you can get the latest edition of Blue Wave Energy Partners Pipeline. Gate's of the Arctic. This journey will take you through some of the most breathtaking terrain but also some of the most beautiful scenery north of the Arctic Circle.

 It follows the BWEP Pipeline through the mountains and even crosses over the dangerous Atigun Pass. Helicopter and fixed wing pilots will be challenged up here.

 It's taken quite some time to get this edition of BWEP ready for prime time. I think the payoff is worth all the work it takes.

Hope you like it and please post some screenshots if you get the chance too. Here's a few I took:










Brad

5
General Discussion / Re: Happy Thanksgiving to the US contigent
« on: November 29, 2019, 11:01:47 AM »
Flying back to Misty's Place yesterday, the aircraft needed some aileron trim towards the right side of the cockpit to keep things straight and level.

 :-[

6
Addon Scenery and Enhancements / Coming Soon: BWEP-Gates of the Arctic
« on: November 28, 2019, 11:27:32 AM »








7
General Discussion / Re: MSFS is alive
« on: November 28, 2019, 08:57:44 AM »
Great looking vehicles and the effects are very well done. A perfect fit for the Medical Dispatches for one.

8
General Discussion / Re: Happy Thanksgiving to the US contigent
« on: November 28, 2019, 08:55:12 AM »
Thank you Sir! Time to put on a few pounds!

9
General Discussion / Re: MSFS is alive
« on: November 27, 2019, 09:33:52 AM »
 I am hopeful that RTMM and our current scenery areas will continue to be relevant for at least a few more years. We should all just sit back and enjoy our hobby in its current form until the new platform is released. Then decide.

 Some of us will continue using P3D, FSX, etc. and others will immediately make the jump to FS2020. There's no need to throw in the towel for awhile. I'm pretty sure that we will have a home here for awhile.

Just my 2 cents.

10
Misty Flying Club and Multi Player / Re: MFC Tour Completions
« on: November 13, 2019, 04:37:50 PM »
Completed the "X" Factor. Great trip to some unique scenery spots.

Thank you

11
Screenshots / Re: Trick or Treat...tis the season!
« on: October 26, 2019, 02:05:39 PM »
Scares me!! As always a great job Robert!

12
Screenshots / Re: Petersburg Exploration
« on: October 22, 2019, 05:33:17 PM »
Great shots.

Thanks for sharing these.

13
Screenshots / Hawaii Photo-real with ENVTEX Sky Textures
« on: October 16, 2019, 07:06:38 PM »
Taken during a recent flight at sunset around the island of Oahu, I was very happy to see the results using TOGA products ENVTEX texture sets around the Flight Sim Jewels Hawaii Photo-real scenery. Starting at Kaneohe Bay and traveling towards the North Shore.


















14
Screenshots / Re: How cool is this?
« on: October 14, 2019, 04:21:54 PM »
Dieter,

Yes sir. And as Mike also let me know I did update my original post mentioning Jay as the original design source and Mike with the update. Sorry, I missed that originally. But Wood Lake has been installed on my system for several years and I didn't remember the original read me when I posted this the other day.

I love the combined efforts we sometimes get to produce something like this. It's great stuff.

Thanks to all

Brad

15
Screenshots / Re: How cool is this?
« on: October 13, 2019, 09:05:33 PM »
Hi,
I don't want to be here adorned with strange feathers.

The creator of the scenery is Jay Langham.
He deserves the honor!

I made this FS9-Scenery compatible only for the FSX/P3D.

 Thank you Mike for bringing this to my attention. I’ve updated my original post to show the credits properly.

Pages: [1] 2 3 ... 122