Misty Moorings Forums

Return to Misty Moorings (FSX/P3D/MSFS2020) => Help and Troubleshooting => Topic started by: LTCSZ on February 11, 2019, 05:35:12 PM

Title: Library Order Once and For All!
Post by: LTCSZ on February 11, 2019, 05:35:12 PM

Where should the Tongass Upper and Lower files be located in the Scenery Library...I have mine listed as 1 and 2 with everything else below them...Is this correct? Running FSX...Thanks!

Title: Re: Library Order Once and For All!
Post by: Beardgoblin on February 11, 2019, 06:16:22 PM

Hi LTCSZ,

check out the load order under the Scenery getting started page http://return.mistymoorings.com/getting_started/index.php (http://return.mistymoorings.com/getting_started/index.php)

Scroll down to #8 for the Scenery Load Order advice.

And from new guy to another, welcome to RTMM  8)

Title: Re: Library Order Once and For All!
Post by: nbrich1 on February 11, 2019, 07:33:24 PM

In other words   Tongass goes between FTX and OpenLC (FTXCentral)  (And RTMM on top).

Do this you are actually creating scenery blocks - then you can move things around as required inside the scenery blocks.

So top down:
 
3rd party add-ons block
RTMM Scenery: Libs go at bottom, add-ons scenery above.

FTX Block
FTX (ORBX) entries ... ORBX Entries (See FTX Central Discussion below)

Tongass Block
Tongass X Higher Priority ... from the Tongass X Installation   (Higher goes above lower!)
Tongass X Lower Priority ... from the Tongass X Installation

OpenLC Block
ORBX!OPENLC (if you have it) (See FTX Central Discussion below)

Below is the bases stuff, mesh and default sim scenery.

To set up these blocks: set the FTXCentral insertion points.