Misty Moorings Forums

Return to Misty Moorings (FSX/P3D/MSFS2020) => Object Libraries for RTMM => Topic started by: xxd09 on October 26, 2017, 03:25:38 PM

Title: Placement
Post by: xxd09 on October 26, 2017, 03:25:38 PM

Hi All
Just a small but annoying point
In P3Dv4.1 every time I load a new airport -Orbyx or from another designer my 10 RTMM libraries move back to the bottom of the last Orbyx scenery areas that I have-in my case ORBYX!OPENLC_NAMERICA2
I then have to move them back to above OrbyxLibs
Any cure for this?
xxd09

Title: Re: Placement
Post by: spud on October 26, 2017, 06:00:50 PM

Use the FTX Central program to set your insertion points.  Example attached.  If you have OZx and Tongass Fjords X software.

Click to enlarge

Title: Re: Placement
Post by: jeff3163 on October 26, 2017, 07:45:00 PM

Spud, I am up to version 3.2.3.0 of FTX Central.  You're showing v3.2.1.1 there. ;)   

xxd09,
     Choose the lowest RTMM library and use that for the FTX insertion point, if you don't have OZx.  All FTX will load in below that.  Then choose TFX as the insertion point for OLC, and it will always load below TFX, which is below all FTX, right.  That keeps it all sorted.   8)

Title: Re: Placement
Post by: Penzoil3 on October 27, 2017, 12:54:15 AM

 8)
 3.2.3 is only available if you have opted into the fastlane beta program.
https://orbxsystems.com/forum/topic/139402-objectflow-2-open-beta/

Title: Re: Placement
Post by: spud on October 27, 2017, 02:05:21 PM

Correct Sue,
Due to the fact that I'm having to rebuild my entire HD/FSX installation and I'm tired of being a BETA tester and did not opt into Objectflow 2.  >:(
 8)

Title: Re: Placement
Post by: xxd09 on October 27, 2017, 07:10:17 PM

Hi jef3163
Thanks for that-all working now
xxd09