Vancouver+

[stiletto2]

Hi Jeff,

Assume you are using Van+ v3.  Enjoyed your pics splashed across my 3 screens with bezel adjusted.  Very nice!   Check your email...

Rod

[stiletto2]

On another Van+ v3 note......be careful about putting in the folders for SimObjects\Airplanes.   The Van+ v3 DHC3 and DHC6 folders are not FSX models and could cause issues in P3Dv4.  The DHC2 folder is good and the Boat and Rotorcraft models are FSX compliant so no problem with those.

Probably could sub in the DHC3 and DHC6 models from my TFX update but not sure about that since Van+ v3 uses multiple models for each plane type.  There is already enough frame rate drag on my triple screen system so not going to get into that for now. 

Rod

[jeff3163]

Hi Jeff,

Assume you are using Van+ v3.  Enjoyed your pics splashed across my 3 screens with bezel adjusted.  Very nice!   Check your email...

Rod

Hi Rod,
     Yes, v3.  Thanks.  Got the email.
     I am back to three monitors again.  The backlights recently went out in one of my monitors.  I ordered a repair kit (ShopJimmy.com) , and replaced the backlights myself.  My Vizios are "obsolete".  I fixed it, and it is good as new now.  I got repair kits for the other two monitors, for when they go. 
     I couldn't wait to get back to three monitors, because of the center split of the double monitors makes me cross-eyed! 
     My sim is looking pretty nice, so far.  I like the 64-bit version much better than any previous sim.    

[stiletto2]

Hi Jeff,

Forgot to mention that, as far as I know,  Vic+ for PNW (v8) doesn't modify terrain.cfg so no terrain block is needed.

Rod

[NeptuneP2V7]

Thank Jeff is in the box 

Patrick

[dexthom]

Hi Jeff,

Forgot to mention that, as far as I know,  Vic+ for PNW (v8) doesn't modify terrain.cfg so no terrain block is needed.

Rod

As I recall, that was in there for the folks who had the Ultimate Terrain package.  Not needed for PNW.