Author Topic: Placement  (Read 3436 times)

xxd09

  • Member
  • ***
  • Posts: 347
Placement
« on: October 26, 2017, 03:25:38 PM »
Hi All
Just a small but annoying point
In P3Dv4.1 every time I load a new airport -Orbyx or from another designer my 10 RTMM libraries move back to the bottom of the last Orbyx scenery areas that I have-in my case ORBYX!OPENLC_NAMERICA2
I then have to move them back to above OrbyxLibs
Any cure for this?
xxd09

spud

  • Misty Moorings Team
  • Hero Member
  • *
  • Posts: 3,082
Re: Placement
« Reply #1 on: October 26, 2017, 06:00:50 PM »
Use the FTX Central program to set your insertion points.  Example attached.  If you have OZx and Tongass Fjords X software.

Click to enlarge
Later,

Spud

jeff3163

  • Misty Moorings Team
  • Hero Member
  • *
  • Posts: 4,103
  • Watercraft-Panels-Paint
Re: Placement
« Reply #2 on: October 26, 2017, 07:45:00 PM »
Spud, I am up to version 3.2.3.0 of FTX Central.  You're showing v3.2.1.1 there. ;)   

xxd09,
     Choose the lowest RTMM library and use that for the FTX insertion point, if you don't have OZx.  All FTX will load in below that.  Then choose TFX as the insertion point for OLC, and it will always load below TFX, which is below all FTX, right.  That keeps it all sorted.   8)
« Last Edit: October 26, 2017, 07:49:23 PM by jeff3163 »

Win10Pro64, MSFS 1.25.9.0, P3Dv4.3.29.25520, AMD Ryzen7 1800X@3.6 GHz , 32Gb RAM, GTX 1080 Ti, 2x42" Vizio Monitors, HTC Vive VR HMD, Saitek Yoke/Pedals/trim wheel, XBox360 Controller, G27 steering wheel w/shifter+pedals. :P

Penzoil3

  • Sr. Member
  • ****
  • Posts: 634
Re: Placement
« Reply #3 on: October 27, 2017, 12:54:15 AM »
 8)
 3.2.3 is only available if you have opted into the fastlane beta program.
https://orbxsystems.com/forum/topic/139402-objectflow-2-open-beta/

spud

  • Misty Moorings Team
  • Hero Member
  • *
  • Posts: 3,082
Re: Placement
« Reply #4 on: October 27, 2017, 02:05:21 PM »
Correct Sue,
Due to the fact that I'm having to rebuild my entire HD/FSX installation and I'm tired of being a BETA tester and did not opt into Objectflow 2.  >:(
 8)
Later,

Spud

xxd09

  • Member
  • ***
  • Posts: 347
Re: Placement
« Reply #5 on: October 27, 2017, 07:10:17 PM »
Hi jef3163
Thanks for that-all working now
xxd09